HELP with tranny mounts

[steph74]

Hi everybody

OK I am in the middle of changing my transmissionmount. O'reilly gave me a mount that is supposed to be for my jeep year and model and also transmission.... it lloks that it is not the same one that I pulled and so I went to check.... all search I have done so far gives me the same part# they gave me... but it is so different I doubt it.

So who can confirm for me the right type of transmission mount ? and maybe give me a source for it

Cherokee Laredo 89 MANUAL BA10/5 peugeot.
They gave me the part #2625 ANCHOR transmission mount
http://www.oreillyauto.com/site/c/search/Mount+-+Manual+Transmission/03272/C0338.oap?forcedVehicle=true&year=1989&make=Jeep&model=Cherokee&vi=1179941

[4.3LXJ]

If I remember correctly, the BA10 did have a different mount.

The best I could come up with in a short amount of time is this:

http://www.4wd.com/productdetails.aspx?partID=7825

I would call these folks. They probably have just the tranny mount available. Also call 4 Wheel Parts too.

[steph74]

oh thanks I guess i forgot to update ;)

This is actually the part that fits the BA10/5
I found it at different location including quadratec and teamcherokee and 4WD
http://www.teamgrandwagoneer.com/parts/Detailed/1700.html

it is expensive but since it is an essential part I guess I will bite the bullet ;) not too much choice, the rubber on mine fell apart and 2/4 studs that attach to the cross member are gone...

from my search it is the same part number as the wrangler YJ....

However if I the mount that you show was thin enough to fit I could go cheaper way and get only that... sounds like a good idea ... but is it lol ?

[4.3LXJ]

oh thanks I guess i forgot to update ;)

This is actually the part that fits the BA10/5
I found it at different location including quadratec and teamcherokee and 4WD
http://www.teamgrandwagoneer.com/parts/Detailed/1700.html

it is expensive but since it is an essential part I guess I will bite the bullet ;) not too much choice, the rubber on mine fell apart and 2/4 studs that attach to the cross member are gone...

from my search it is the same part number as the wrangler YJ....

However if I the mount that you show was thin enough to fit I could go cheaper way and get only that... sounds like a good idea ... but is it lol ?

Not really sure the pic was completely accurate. The one showed had no bracket for the exhaust. However if you have a separate piece for that, then go for it.

[steph74]

if that works I'll be mad lol I just changed the motor mounts I could have a good deal by getting that kit lol

[4.3LXJ]

It probably will. All the rest of the tranny/exhaust mounts are two piece.

[BlueXJ]

I have been told that the later AX15 mount can be altered to fit too. Never done that but it sounds possible.

[4.3LXJ]

It is really a matter of redrilling the top plate or adding an adapter plate. Advance Adapters makes a plate to fit the AX15 on the BA10 mount. You can go the other way.

[steph74]

yeah well after searching a solution and because my drilling skills are not that great I went with OEM.

So I ordered it today..... $90 with shipping :sad0147:

But the good news is that I stopped by the dearlership in town and asked them about it... $385 if I wanted it :stars:

So not too bad in the end lol


So for info, this is really the only mount that there is for the BA10/5. No aftermarket possibility without a little modifications.