Mudderoy
03-08-2009, 12:37 PM
This is easier than putting gas in your XJ!
I ordered these on 11-04 and they arrived USPS 11-08. I purchased them from Howler_GT on CherokeeTalk.com.
They were packed well. All the edges were smooth to the touch. No cut fingers!!! Always a plus. I was concerned that they were not going to fit well enough to get the screws in straight, but all fears went away as I screwed it down.
This is a simple and inexpensive upgrade to your XJ which I recommend!
http://muckleroy.com/images/Jeep_sill1.jpg
Here is how it arrived (closed of course)
http://muckleroy.com/images/Jeep_sill2.jpg
Out of the package...
http://muckleroy.com/images/Jeep_sill3.jpg
Unwrapped
http://muckleroy.com/images/Jeep_sill4.jpg
Factory plastic sill
http://muckleroy.com/images/Jeep_sill5.jpg
Removal of factory Phillips head screws...
http://muckleroy.com/images/Jeep_sill6.jpg
Slide the plastic sill out of the way...
http://muckleroy.com/images/Jeep_sill7.jpg
Slide the aluminum sill in place (the screws will pull it down flush)
http://muckleroy.com/images/Jeep_sill8.jpg
Use the stainless screws supplied with new sills...
http://muckleroy.com/images/Jeep_sill9.jpg
Slightly different angle...
http://muckleroy.com/images/Jeep_sill10.jpg
Factory rear door sill. 2 screw removal, slide out and slide in the new sill.
http://muckleroy.com/images/Jeep_sill11.jpg
Driver's side complete. Again the stainless steel screws will pull down the sill
I ordered these on 11-04 and they arrived USPS 11-08. I purchased them from Howler_GT on CherokeeTalk.com.
They were packed well. All the edges were smooth to the touch. No cut fingers!!! Always a plus. I was concerned that they were not going to fit well enough to get the screws in straight, but all fears went away as I screwed it down.
This is a simple and inexpensive upgrade to your XJ which I recommend!
http://muckleroy.com/images/Jeep_sill1.jpg
Here is how it arrived (closed of course)
http://muckleroy.com/images/Jeep_sill2.jpg
Out of the package...
http://muckleroy.com/images/Jeep_sill3.jpg
Unwrapped
http://muckleroy.com/images/Jeep_sill4.jpg
Factory plastic sill
http://muckleroy.com/images/Jeep_sill5.jpg
Removal of factory Phillips head screws...
http://muckleroy.com/images/Jeep_sill6.jpg
Slide the plastic sill out of the way...
http://muckleroy.com/images/Jeep_sill7.jpg
Slide the aluminum sill in place (the screws will pull it down flush)
http://muckleroy.com/images/Jeep_sill8.jpg
Use the stainless screws supplied with new sills...
http://muckleroy.com/images/Jeep_sill9.jpg
Slightly different angle...
http://muckleroy.com/images/Jeep_sill10.jpg
Factory rear door sill. 2 screw removal, slide out and slide in the new sill.
http://muckleroy.com/images/Jeep_sill11.jpg
Driver's side complete. Again the stainless steel screws will pull down the sill