tbone
05-23-2010, 12:26 AM
It's been a while coming but here it is: I drilled a half inch hole on the roof.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall001.jpg
Sprayed with primer and installed grommet.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall002.jpg
Fed wires through the roof after putting them in wire loom.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall003.jpg
Pulled through to the inside, both hot wires run down the A pillar and the ground wire will be grounded where they are.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall004.jpg
I drilled a half inch hole in the side of the glovebox and pulled the wires through, then I drilled a inch and a half hole through the back of the glovebox into the cowl area to feed the wire outside.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall008.jpg
I drilled another inch and a half hole into the cowl area under the hood and I mounted the relays on the inner fender next to the battery, the third relay will be for the lights on my hood.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall006.jpg
Lights installed, I removed the yellow light I had in the middle, I have another idea for it.
http://i674.photobucket.com/albums/vv110/tbone64_2009/My%20XJ/offroadlightinstall010.jpg
Here are the switches, the bottom one controls the outside lights, the next the inside lights, the third switch will control the lights on the hood and the last one will go to my OBA when it is finished.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall009.jpg
Here they are at night, not to bad for the Cheap Wal-Mart KC lights and even with both sets on it has less of a draw on my alt than the factory headlights do.
http://i674.photobucket.com/albums/vv110/tbone64_2009/My%20XJ/offroadlightinstall012.jpg
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall001.jpg
Sprayed with primer and installed grommet.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall002.jpg
Fed wires through the roof after putting them in wire loom.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall003.jpg
Pulled through to the inside, both hot wires run down the A pillar and the ground wire will be grounded where they are.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall004.jpg
I drilled a half inch hole in the side of the glovebox and pulled the wires through, then I drilled a inch and a half hole through the back of the glovebox into the cowl area to feed the wire outside.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall008.jpg
I drilled another inch and a half hole into the cowl area under the hood and I mounted the relays on the inner fender next to the battery, the third relay will be for the lights on my hood.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall006.jpg
Lights installed, I removed the yellow light I had in the middle, I have another idea for it.
http://i674.photobucket.com/albums/vv110/tbone64_2009/My%20XJ/offroadlightinstall010.jpg
Here are the switches, the bottom one controls the outside lights, the next the inside lights, the third switch will control the lights on the hood and the last one will go to my OBA when it is finished.
http://i674.photobucket.com/albums/vv110/tbone64_2009/offroadlightinstall009.jpg
Here they are at night, not to bad for the Cheap Wal-Mart KC lights and even with both sets on it has less of a draw on my alt than the factory headlights do.
http://i674.photobucket.com/albums/vv110/tbone64_2009/My%20XJ/offroadlightinstall012.jpg