Rise block dimensions

[packmule1911]

I have access to milling machines at night school, and thought I'd make some 2" rise blocks for a modest little low-cost lift for my new 00' daily driver. Does anyone have good dimensions, or blueprints for a 2" riser block that can be shared?

Thanks.

[4.3LXJ]

If you are talking about lift blocks for the rear axle, it is generally considered a bad thing. Our XJ springs are too flimsy for lift blocks because of axle wrap. I have made 1" blocks out of 2.5X1/2" plate drilled to accept the center bolt and bolted to the spring