Mudderoy
01-14-2019, 06:52 AM
For sometime now I've had a problem with the down pipe bouncing, rattling, on the cross member.
I tried bending the hanger by jacking up the down pipe and it would stop for a while then come back.
I've replaced the down pipe twice since I've owned the Jeep and this last time I saw where one of my exhaust leaks were. The metal tore where the hanger was welded to the down pipe, probably from me jacking it up.
14651
When I had the cross member out for Atlas install I remove a little bit of the cross member to make a bit of a gap, but it's still touching.
I decided to try something new.
14652
Amazon didn't have a single hanger to do what I wanted so I purchased two.
https://amzn.to/2RLt80Z and https://amzn.to/2TQTBHU
I tried bending the hanger by jacking up the down pipe and it would stop for a while then come back.
I've replaced the down pipe twice since I've owned the Jeep and this last time I saw where one of my exhaust leaks were. The metal tore where the hanger was welded to the down pipe, probably from me jacking it up.
14651
When I had the cross member out for Atlas install I remove a little bit of the cross member to make a bit of a gap, but it's still touching.
I decided to try something new.
14652
Amazon didn't have a single hanger to do what I wanted so I purchased two.
https://amzn.to/2RLt80Z and https://amzn.to/2TQTBHU