Infidel Edition
06-01-2016, 09:59 PM
OK. The '93 axle is a High Pinion as I understand....
.... Correct?
96+ is the low pinion?
And I referenced a chart somewhere that says for a 5" lift, I want a 5* caster.
4" was like 5.5* ...
I know that I can put a large socket over the upper ball joint nut.... And the angle finder on top of that.
That's all good.
Here's my question. When I don't have a perfectly flat spot to park on... is there a 90* reference to use? = if I release the parking brake, I'll roll. Slowly, but it'll roll.
Thus, on a 5* slope.... I'm suddenly setting my caster to 10* or to 0* pending on up hill vs down hill.
.... Correct?
96+ is the low pinion?
And I referenced a chart somewhere that says for a 5" lift, I want a 5* caster.
4" was like 5.5* ...
I know that I can put a large socket over the upper ball joint nut.... And the angle finder on top of that.
That's all good.
Here's my question. When I don't have a perfectly flat spot to park on... is there a 90* reference to use? = if I release the parking brake, I'll roll. Slowly, but it'll roll.
Thus, on a 5* slope.... I'm suddenly setting my caster to 10* or to 0* pending on up hill vs down hill.