1992/1993 transfer case swap help!

[bscg2000]

Hello, I swapped the transfer case out of my 92 xj with one out of a 93. Both are 231's. Both were exactly the same with the exception of the one plug on the tail end of the transfer case that sets on top of the housing where the rear driveshaft is. I can't remember right off which was which but one was for a 2 prong set up and the other was a 3 prong set up. I did not notice this until after it was in and that was the only thing left to hook up as far as wires go anyway. What's the easiest was to fix this issue? Thanks in advance!

[4.3LXJ]

That would be speed sensor. It should unscrew. Just swap them

[bscg2000]

Alright thanks again Steve! Is there any way to do it without pulling the transfer case back out again?

[4.3LXJ]

We are talking about a plug on the tail housing right?

[bscg2000]

Yes. I just looked again and feel stupid now. Its fixed. I couldn't remember exactly what it looked like and wasn't home when I posted. Just got home and looked. Already fixed it.

[4.3LXJ]

Okie dokie Brandon

[bscg2000]

Thanks again though.