Toe-in specs Please !

[DanXJ97]

I have a 1997 Cherokee with the D30 front axle and would like the toe-in specs please. Thanks, Dan

[4.3LXJ]

About as close as you can get with a tape measure is 1/8" toe in

[OldFaurt]

About as close as you can get with a tape measure is 1/8" toe in

I run about an 1/8" and get pretty good results.
If you have fresh ball joints & tie rod ends, you could get by with less.

That is not technical advice, it is what I have run successfully.

http://www.go.jeep-xj.info/HowtoAlignment.htm

There are some very good mechanics on this site I am sure will give you advice as well. That should keep you safe enough for the time being.