View Full Version : Toe-in specs Please !
DanXJ97
12-12-2014, 07:37 PM
I have a 1997 Cherokee with the D30 front axle and would like the toe-in specs please. Thanks, Dan
4.3LXJ
12-12-2014, 07:39 PM
About as close as you can get with a tape measure is 1/8" toe in
OldFaurt
12-12-2014, 08:54 PM
About as close as you can get with a tape measure is 1/8" toe in
I run about an 1/8" and get pretty good results.
If you have fresh ball joints & tie rod ends, you could get by with less.
That is not technical advice, it is what I have run successfully.
http://www.go.jeep-xj.info/HowtoAlignment.htm
There are some very good mechanics on this site I am sure will give you advice as well. That should keep you safe enough for the time being.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.