Rear lift isnt level

[silver_xj]

Hello everyone.

Over the weekend I installed .75 spacers an shackles. The front can out even but the rear isn't. The drivers site sites almost and inch lower. Everything was torqued on the ground. I have stood on the rear bumber and bounced up and down a few times in an attempts to get everything to settle more. Any ideas? Is it possible I F'd up the spring pack by using a jack to get the holes to line up? I only had to use the jack on the drivers side.

[nickyg]

What brand of shackles? is it possible one is on upside down? I don't know if that matters or not, just thinking aloud.

[4.3LXJ]

I think I need some pics of everything before I can make a guess at this

[silver_xj]

@ NickyG - Shackles are from Rusty's and it is not possible to mount them upside down.
@ 4.3 - What would you like pics of?

[4.3LXJ]

The shape of the leaf spring on both sides for comparison, the shackles and angles they are at. Stuff like that

[silver_xj]

***EDIT***
Measurements taken from the ground to the middle of the fender. Using the center of the wheel/tire and fender for reference.

Pics Here; http://imageshack.us/g/1/10337261/

Measurements Taken Twice.
Round 1
DF 36 1/4, DR 36 1/4, PF 36 3/8, PR 36 1/4
Round 2
DF 35 1/2, DR 35 3/8, PF 35 5/8, PR 35 1/2.

[KMW-NWXJ]

That only looks like 1/8" difference to me. Am I missing something?

Sent from my C811 4G using Tapatalk 2

[silver_xj]

Is that normal? The pass side rear just looks to high to me... Maybe I'm just paranoid I f*d up the leaf pack..

[Carves]

Doesn't look too bad from down here .. ;);)

Centre of wheel cap to a point on the body - is generally a better measurement - than using the ground as a start point.

Drivers side springs tend to sag a bit after a while.

4.3LXJ will probably have some ideas to deal with your vertical looking rear hangers.

[silver_xj]

Now that I think about it. The drivers side rear and passenger side front were my guinea pigs for this install...

[silver_xj]

I didn't go from the center of the wheel cap for my measurements as its much harder to find the center of a round object compared to a flat one.

[4.3LXJ]

Personally I don't see anything wrong here. It is within 1/8" which is good in my book. I think mine is off by that much which will change depending on who gets in it. What I wanted to see on the shackle angle is if they were the same side to side. I don't think yo have anything to worry about. We have a thread in the tech section on how to tell true lift height.