Infidel Edition
07-29-2013, 03:40 PM
OK. So way back in the beginning, I was looking for a valve/drainage system.
I went with the Scupper Valve (Amazon.com: Invincible Marine Cockpit Scupper Valve: Sports & Outdoors@@AMEPARAM@@http://ecx.images-amazon.com/images/I/41CFQbwyiqL.@@AMEPARAM@@41CFQbwyiqL for $5.88 /ea). One behind the Driver Seat & One behind the Passenger Seat.
And a 2" drain cover from HomeDepot (for $1.75 /ea).
I chose the plug with the grooves running from front to rear as those are the most likely to provide the best drainage channel.
Here's the pic's:
3221
3222
3223
3224
From inside looking down:
3225
From under looking up:
3226
Now, I just have to sand the surfaces smooth ~ and apply the bedliner to match the rest of the floor.
...not sure if I'm going to leave the cover silver or make it bedliner too.
I'll post a final "Ripped It Out" section once I finish the flooring and side panels.
I went with the Scupper Valve (Amazon.com: Invincible Marine Cockpit Scupper Valve: Sports & Outdoors@@AMEPARAM@@http://ecx.images-amazon.com/images/I/41CFQbwyiqL.@@AMEPARAM@@41CFQbwyiqL for $5.88 /ea). One behind the Driver Seat & One behind the Passenger Seat.
And a 2" drain cover from HomeDepot (for $1.75 /ea).
I chose the plug with the grooves running from front to rear as those are the most likely to provide the best drainage channel.
Here's the pic's:
3221
3222
3223
3224
From inside looking down:
3225
From under looking up:
3226
Now, I just have to sand the surfaces smooth ~ and apply the bedliner to match the rest of the floor.
...not sure if I'm going to leave the cover silver or make it bedliner too.
I'll post a final "Ripped It Out" section once I finish the flooring and side panels.