View Full Version : For a certain somebody :)
XjJeepacorn
06-12-2013, 11:00 PM
I've been working on this for a week or so...
Making an air filter compartment for the snorkel. Snorkel got shipped to me and part of it was broke got a refund and got to keep it so I'm making it 3" all the way from the par that connects to the snorkel bit that goes to the out side right to the thing that comes to the intake manifold.
2543
2544
2545
254625472548.
XjJeepacorn
06-13-2013, 08:13 AM
More!
25492550
This is where I cut the excess tube :)
XjJeepacorn
06-13-2013, 08:19 AM
The opposite end!, I've changed my mind though I'm not going to use that stuff coming off it it's going to be 3" abs all the way to the snorkel thing.
2552
2551
25532554
2555
XjJeepacorn
06-13-2013, 08:24 AM
Next up was dealing with this:
2556
2557
Decided to go with one of these it looked like it might fit but then it needed a little modification to fit.
2558
XjJeepacorn
06-13-2013, 08:40 AM
Here we go!
2559 label everything! Male and female :)
2560
2561
This one was hard! ^^
2562
Unclip that sucker too!
2563
25642565
256625672568
25692570
The last one there is the actual washer bottle hoses and wiring
2571257225732574
2575
^^^ shhhh lol
2576
2577
XjJeepacorn
06-13-2013, 08:50 AM
I used my old washer bottle to cut out parts to make up what I cut out of the old one
2579
2580
Just a test run to double check it fit before I super glued and rvted it in
2581
2582
Ta da!
2583
2584
2585
I moved the main harness over top the break booster to give me more room and I cut off the pinch seam with my angel grinder because its in the way.
2586
Then last night I cut out the other end of the lid that twists off and has a gasket. Also cut 1/4 inch bend abs and grinder it down a bit so it would slide into the intake tube thing.
2589
25902591
That's it so far, check out my other thread :)
http://www.jeepacornforum.com/viewtopic.php?f=57&t=123
XjJeepacorn
06-13-2013, 11:09 AM
This is the filter I'll be using
http://www.knfilters.ca/search/product.aspx?Prod=RX-4020-1
XjJeepacorn
06-21-2013, 08:53 PM
I'm just about done I've been running it for a couple days just have to add some silicone around the seams to go over kill lol
2630
All in all I spent about 90 - 100 bucks on everything better then buying the inline thing for me. I think it was like 120 or 130 or something then shipping and then duty and handling fees would have put it close to 200 so I am happy with it.
XjJeepacorn
06-21-2013, 08:54 PM
2631
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.