Locker Install Question

[dagr8tim]

I think Tony has installed an Aussie in his 8.25, but I'm not sure.

I just got an Aussie for my 29 spline 8.25 and was wondering. Can I just remove the center pin, pop the c clips, and pull the axles out about 6 inches to install the locker? Or does the carrier have to come out?

I can't find any youtube video's or information specific to the 8.25.

[OrangeXJ]

I think the carrier has to come out

[msmoorenburg]

I think Tony has installed an Aussie in his 8.25, but I'm not sure.

I just got an Aussie for my 29 spline 8.25 and was wondering. Can I just remove the center pin, pop the c clips, and pull the axles out about 6 inches to install the locker? Or does the carrier have to come out?

I can't find any youtube video's or information specific to the 8.25.

you can just pop the pin and pull the clips and install the locker. RTM the last step can be a pain putting the clip back in if you don't read the manual.

[4.3LXJ]

I have installed two Aussies and found it easier to remove the carrier both times. But you can do it either way

[bigjim350]

I would remove it if it was in the front diff or a d35. But not A 8.25 because when you reinstall it you will have to readjust those preload adjusters on both sides which can be a pain. And since the 8.25 has a bolt holding the pin in instead of a roll pin, its really not that bad to do it while in the diff.

Sent from my nerdy smartphone

[xjmarc]

You have to install the locker with the carrier in the housing otherwise you wouldn't be able to put the c-clips on you axle shafts. If you have an axle that doesn't use c-clips it's easier to to do on your work bench.